Cables - Aquatic Equipment

Aquatic Equipment
Go to content
Products > Neptune

Cables

The Aquabus cables are used to connect modules to your system. Although these cables are included with each module, you may need different or longer cables..


Aquabus cable M/M 900 cm ABUS30
Cables
Article number: ABUS30

Use this cable to connect Apex Systems and modules together.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex, Modules, and Energy Bars together. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.

This is a thirty foot Male/Male Aquabus cable that connects one module to another or connects to an Aquabus extension cable. This cable is intended to connect modules from one location to another. It is not included with any of our products. This is a great solution when your filtration area or life support area is in a different location from your aquarium.
Immediate availability
R 645.00(VAT incl.)
Add
Aquabus extension cable M/F 900 cm ABUS30EXT
Cables
Article number: ABUS30EXT

Use this cable in combination with a standard AquaBus cable to extend the length.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to extend the length of another AquaBus cable. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.

This cable has a Female connector on one end and a male connector on the other.

This is a thirty foot Male/Female Aquabus cable that is used as an extension cable to connect Neptune Systems’ products over great distances. So if you have the aquarium in your basement and your other aquarium in your kitchen (because who has just one aquarium?), then you can control all of that from one Apex System! Use the 30′ Aquabus cable along with the 30′ Aquabus extension cable, then you can run two aquariums that are 60 feet apart.

NOTE: You can have up to 200′ of Aquabus cable per system and it is recommended that you have one powered Neptune Systems accessory (i.e. Energy Bar or 1LINK module) every 75′.
Immediate availability
R 645.00(VAT incl.)
Add
Aquabus cable M/M 457 cm ABUS15
Cables
Article number: ABUS15

Use this cable to connect Apex Systems and modules together.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex, Modules, and Energy Bars together. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.
Immediate availability
R 445.00(VAT incl.)
Add
Aquabus extension cable M/F 457 cm ABUS15EXT
Cables
Article number: ABUS15EXT

Use this cable in combination with a standard AquaBus cable to extend the length.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to extend the length of another AquaBus cable. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.

So if you have a 3′ foot Aquabus cable that came with your PM2 and need to go 18′, then the 15′ extension cable is the perfect solution to make that 18′ distance possible.

This cable has a Female connector on one end and a male connector on the other.
Immediate availability
R 445.00(VAT incl.)
Add
1LINK Male to Male Cable 3 meter CBL-1LINK-MM-10
Cables
Article number: CBL-1LINK-MM-10

This is a ten foot Male/Male 1LINK cable that allows you to connect one 1LINK device to another. This is a perfect cable when you are using the Neptune Systems’ DŌS— If you have a 1LINK connection free on your 1LINK module or Energy Bar 832, then you can toss the DŌS Aquabus cable and the power supply aside and just use this single cable!

Ultimately, this will help save time in wire management and you can spend more time with your aquarium and less time managing wires.
Immediate availability
R 445.00(VAT incl.)
Add
1LINK Male-Female Cable - 3 meters 1LINK-EXT
Cables
Article number: CBL-1LINK-EXT

This is a ten foot Male/Female 1LINK cable that can be used as an extension cable. This cable is a great solution to extend the cables on your 1LINK devices when your Apex or 1LINK is located further away from your aquarium.

NOTE: No single run of your 1LINK cables can be longer than 20′.
Immediate availability
R 445.00(VAT incl.)
Add
DC24 Male-Female Cable - 3 meters - 10'
Cables
Article number: CBL-DC24-EXT

This is a ten foot Male/Female extension cable that will enable you to remotely locate DC24 accessories like the PMUP.

NOTE: The maximum supported DC24 cable length between a DC24 port and the PMUP or other 24VDC device is ~20 feet.
Immediate availability
R 445.00(VAT incl.)
Add
DC24 Male detachable cable 3m - 10'
Cables
Article number: CBL-DC24-BARE-10

This is ten foot cable that has the DC24 connector on one end and two tinned wire leads on the other. The Do-it-yourselfer will love this cable! They can wire any DC24 device to the cable and power it on/off from the DC24 outputs.

NOTE: Device must be rated under 30W.
Immediate availability
R 445.00(VAT incl.)
Add
2 Channel AquaSurf/Apex to Stream Cable SURFCAB2
Cables
Article number: SURFCAB2

2 Channel Apex to stream cable assembly.

It has 1 RJ45 connector which plugs into the Apex base unit, and 2 Din5 connectors which plug into 2 Tunze Controllable Stream pumps.

This enables speed control of up to two TunzeTM Stream pumps that are compatible with the TunzeTM Turbelle 7090 or 7095 Controller.
Immediate availability
R 445.00(VAT incl.)
Add
Aqua illumination to VDM Adapter Cable AICABLE
Cables
Article number: AICABLE

Use this cable to connect Aqua Illuminations Sol and Acan Lighting LEDs to the VDM Module

You can have complete control over your AI Sol and supported Acan Lighting LED Lights using this cable in conjunction with our Advanced LED Dimming Module – VDM.

This is a ten foot cable that has a serial connector on one end that will connect to the serial port on a VDM module. The other end is a 1/8″ plug. This cable allows AI Sol LEDs, Apex Ready+ Acan Lighting LED fixtures, and Apex Ready+ Zetlight LED fixtures to be controlled by the Apex System.
Immediate availability
R 445.00(VAT incl.)
Add
Aquabus cable M/M 183 cm ABUS6
Cables
Article number: ABUS6

Use this cable to connect Apex Systems and modules together.

This is a six foot Male/Male Aquabus cable that connects one module to another. This cable allows you to connect Apex components on opposite sides of your tank. A great example might be to connect an Energy Bar 8 on the right side of your tank and another Energy Bar on the left side of your tank.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex, Modules, and Energy Bars together. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.
Immediate availability
R 345.00(VAT incl.)
Add
2 Channel Light Dimming Cable
Cables
Article number: DIMCAB2

Use this cable to connect two channels of 0-10V dimmable LED lights to your Apex System or Advanced LED Dimming Module – VDM

Use this cable to connect two separate LED color channels from your 0-10V dimmable LED light to the Apex System or the Advanced LED Dimming Module – VDM. This cable has a RJ45 plug on one end and bare wires on the other that must be connected in the manner recommended by your LED manufacturer.

One wire will let you control up to two devices (or channels). This wire opens up many control possibilities with your Apex. For example, it allows you to take off the shelf analog LED drivers and build your own lighting fixture! Of course this still does take some DIY effort but it makes controlling these devices much easier.

If you have four colors of LED that you want to dim, then you will need to buy two of these cables.
Immediate availability
R 345.00(VAT incl.)
Add
Aquabus cable M/M 92 cm ABUS3
Cables
Article number: ABUS3

Use this cable to connect Apex Systems and modules together.

This is a three foot Male/Male Aquabus cable that connects one module to another. This cable is included with some of our expansion modules. The 3′ cable is a great solution for when you have modules in close proximity but not right next to each other.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex, Modules, and Energy Bars together. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.

Immediate availability
R 295.00(VAT incl.)
Add
Aquabus cable M/M 30 cm ABUS1
Cables
Article number: ABUS1

Use this cable to connect Apex Systems and modules together.

The Apex is a modular system that allows you to connect many modules together in either a “daisy-chain” or star topology method. Use this cable to connect together the Apex, Modules, and Energy Bars together. Remember, although this is a USB type cable, the Apex does not have a USB interface. NEVER plug it into any computer or other USB device or it will very likely cause severe damage to your Apex or the device you connect.

This is a one foot Male/Male Aquabus cable that allows you to connect one module to another either under your tank or on a mounting board. The cables are perfect for keeping things tidy by eliminating extra cable— your hobby is keeping aquariums, not wire management.
Immediate availability
R 215.00(VAT incl.)
Add
FOLLOW US
Copyright © 2018 Aquatic Equipment
All rights reserved
CONTACT US

TEL:  +27 31 811 6033
FAX:  +27 31 465 4908
EMAIL:  info@aquaticequipment.co.za
ADDRESS:  60 Alpha Crescent, Durban, South Africa
Aquatic Equipment
Back to content